Hello,
In Geopak, how does one show both the highway off ramp alignment stationing and the mainline alignment stationing on the cross sections? In my case, only the ramp alignment stationing shows when I try to run cross sections for the ramp. FYI the pattern lines in the working file cross over the mainline and the ramp area.
I'll be grateful for technical support.
Sincerely,
Andrea
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Is there any solution yet to show stationing of alignments offset to the center one?
I have a typical case of a divided 3x3 highway, with 3 alignments viz. center, north bound and south bound. I have to cut sections with center line, but while showing/annotating want to show stations of north and south bound as well.
How to accomplish this case?
Any workaround?
Thank you,
Abhiram