GeoPAK Earthwork Input file

Question

I am running Microstation SS2 with GeoPAK and am currently doing earthwork via input files. I have ran several roads today and they have all ran without issues. I have just been doing a "save as" to make new input files and now I am getting this: 
 
 COMPUTING EARTHWORKS FOR BASELINE = ST36WB COMPUTING EARTHWORKS FOR JOB = 162 FORMING LIST OF XSCELLS BEGINNING EARTHWORKS COMPUTATION XS-NOXSCELL no cross-section cells found 
 
 I have triple checked the input file, and have replaced all surfaces in the file I am trying to run the earthwork on. I am stumped along with my other co-workers. We are not on project wise. Does anyone have a solution to this, or at least have seen this issue before? 
 
 Thanks

Ryan Hoefs · Accepted Answer

I figured out that the solution to my problem was to just add a begin and end station since I had different regions on the chain. I assumed it would just grab the stations and ranges off the cells but apparently it wants to know you have ranges before hand.

Beebe Ray · Answer

Make sure all your cross sections are in positive coordinates, so the lower left corner of the lower left section should be in a positive XY position. Make sure the GPK Chain name is the same as the name in the cross section cell. If the chain has recently changed then you may want to recut your sections. You could also open a new dgn file and run your sections into that as a test.