I keep getting the following error when I try to clip a corridor with another corridor: An invalid clipping boundary was encountered and ignored.
What could be causing this?
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Charles (Chuck) Rheault CADD Manager
MDOT State Highway Administration
I guess I can use a complex terrain model.
I'm modeling a linear parking lot that can't be modeled using a simple corridor, so I modeled the pavement and then the curbs. I also used the gutter pan alignments as point controls to limit the widths of the pavement, but I needed the pavement to run slightly wider than the gutter pan.
So I need to clip the pavement at the adjacent corridors after the fact. I think I can start with the pavement surface and merge in the surrounding surfaces and they will trim the terrain at those points.
And I will need to build a new pavement surface model using the trimmed surface to apply a surface template for cross sections.