XIN file won't save

Hello Christiaan,

Are you doing Save as to "Test" or is there any other procedure , please let us know? When I saved as to Test > Load it > closed plan and profile generator dialog box and then reopen it , I could see Test preferences in my drawing. 

Regards,

Purva Lakde

Hi Purva,

Nothing special just Save as close and open and it's gone.

Is there a configvar for the XIN file? I have deleted the XIN file LOCK as you mentioned last time?

R.

CP

Hi Chuck,

Thanks for explanation but I Don't have the knowledge of XML file. I upload the file maybe you or Purva can look at is.

R.

CP

GM_Rail.xin

Screen Capture:

Hello Christiaan,

Thank you for your response.

I have recorded video for you of my system as it's working on my system, please refer the following. When I have gone through your video, I observed you are using Program data to save XIN file, can you please change the path to any other drive or any other folder on which you could have full access or rights and then check if still issue persists or not. Please update us on the same.

Regards,

Purva Lakde

Hi Purva,

I've done some testing and capture my screen so you can see what's happening.

The most strange thing is when I go to the tab Sheet Layout and load the prefs there is a different preference loaded?

Best regards,

Christiaan

I attached a PDF of a report that I have that generates a list of saved preferences. In the Plan & Profile Generator were two - Default and whatever strukton is.

/cfs-file/__key/communityserver-discussions-components-files/5922/GMRailXIN.pdf

I loaded this into Notepad++ and it found no detectable errors. I also loaded it into InRoads Ss4 and was able to call up both preferences and it also allowed me to save one as test.

I was also able to load a profile preference and save it as test and then make it so the preference strukton loads the original profile preference on the Profile Controls tab and make my "test" preference load the new "test" profile preference.

Hopefully someone from Bentley Civil can run some diagnostics on the process and figure out the issue.

Hi Chuck,

thanks for your help, but can you change a preference in the Sheettab and save the file again? That's my point where it goes wrong.

Regards,

Christiaan

Hi Chuck,

thanks for your help, but can you change a preference in the Sheettab and save the file again? That's my point where it goes wrong.

Regards,

Christiaan