I'm using Geopak 08.11.09.872 and I'm trying to place a line using Civil AccuDraw (Station-Offset). I want to place it on my alignment at Station 162+50, Offest 0 but when I activate the draw command the alignment's stationing is not recognized. See below. The alignment has stationing and it is recognized when I run my corridor. I don't have this problem with my other alignments. Any ideas of what could be going on?
Robert Garrett Senior Consultant
www.envisioncad.com
Answer Verified By: Mike Archer
Oh yes that works! Thanks a lot!
Oh how I miss the days of InRoads where you used the "Locate Intersection" tool. Click it, type in the desired station and offset and it snapped right to it. This stupidity that Bentley has conceived with civil accudraw is asinine. I'm batting about .300 as far as getting it to work. STUPID!!!!!!