GEOPAK-PROFILE BY LINEWORK

Question

Hello, 
 
 I am using Power Geopak v8i SS2. 
 I have created a profile from linework using Profile best fit under create profile by PVI method. The profile is created but extends very far to the right, well beyond the extent of the linework I used to create it. Why is the program doing this, and is there a way to avoid it creating extra profile length ?

CADTech1 · Accepted Answer

Beebe Ray, 
 
I did figure it out. Before creating the profile from a line element, I needed to extend each end of line to ensure it matched width of profile/alignment exactly. Once I did that, the profile worked as expected.