[All] End Condition Target: Elevation - How does one use this?

RE: [All] End Condition Target: Elevation - How does one use this?

Derek Schmidt — Mon, 19 Jun 2017 22:29:37 GMT

It would be obvious how to use this if the end condition sought the 0 elevation properly when the value is 0. Why does it not?

RE: [All] End Condition Target: Elevation - How does one use this?

caddcop — Mon, 19 Jun 2017 12:39:23 GMT

I guess you can think about it as a vertical offset from zero.

I've written code for dialog boxes in VB and VBA. It would not be too difficult to make the Offset label change to Elevation when Target Elevation is selected.

RE: [All] End Condition Target: Elevation - How does one use this?

MaryB — Mon, 19 Jun 2017 11:49:46 GMT

So...is that vertical offset your target elevation, or is it "offset" from some other, known item? And I agree - that's going to need better documentation. After seeing this I looked it up, and I would not have figured out that "offset" would be my elevation.

RE: [All] End Condition Target: Elevation - How does one use this?

caddcop — Fri, 16 Jun 2017 20:35:03 GMT

I actually came up with that on my own and was going to post back. Thanks for preventing me from talking to myself! Clearly better instructions are needed, however.

RE: [All] End Condition Target: Elevation - How does one use this?

Adam Wieczorek — Fri, 16 Jun 2017 20:18:51 GMT

To input targeted elevation use Vertical Offset field in your End Condition component properties window: