I have a point control of my slope targeting an existing hinge. 1/3 of the slope displays in the dynamic cross sections but the other 2/3 does not display but the point control is targeting the ex hinge. See image below.
slope (green) displays.
slope does not display but is honoring point control.
the 3d model seems to match where you are cutting the section, I only see a sliver of green in the 3D model at the section location.
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Correct Beebe, only the hinge is showing not the slope. I will have problems with the final 3D line strings because it will not find the slope.