In Openroads Conceptstation, the bridge is invisible

Question

Hi, 
 About Openroads CpnceptStation (Version: cnst10000645en ) 
 I find that the bridge is invisible when placing a bridge, after importing the. alg file. (The green map is from. tin file.) 
 How to do? Obviously, it is not by hide or unhide tool. 
 Please watch the following video. 
 https://youtu.be/PTrTFhTzPco 
 
 Looking forward to your reply！ 
 Zhengpeng

Holly Herring · Accepted Answer

Thanks for sending us the data. Development was able to review your data, and found that ConceptStation v10.00.06.45 does not like the back to back switchback spiral-curve-spiral (SCS) situation. If you leave a short tangent section between ALL SCS curves on that alignment, the bridge will show up in the correct location. They will be addressing this defect in a future release.

Holly Herring · Answer

I tried this using my own data, and did not see this behavior. Have you tried editing the vertical to see if it will create the bridge under certain circumstances? Have you tried using a different alg? It could be data specific if I cannot reproduce the issue. Have you tried creating a new dgndb from scratch to see if you get the same result? If you can, upload your data, and I can try it on my computer with your data: https://communities.bentley.com/help/w/be_communities_help/7079/communities-secure-file-upload.

In Openroads Conceptstation, the bridge is invisible

Top Replies