https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/148515/incorrect-origin-of-stacked-and-sheet-cross-sectionsUsing &quot;Create Cross Sections&quot; within Corridor Modeling, the origin of my design cross sections is placed incorrectly when using stacked or sheet cross sections. They are placed incorrectly when a cross section is going thru a vertical curve. When viewingen-USTelligent Community 12https://communities.bentley.com/thread/452507?ContentTypeID=1Thu, 22 Mar 2018 13:14:41 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:8d873556-4d0f-4f17-88c2-ffc8d47415e5Chris Key<p>The first thing which comes to mind would be if these cross sections are cut at the same station as a template drop.&nbsp; If you are in a vertical curve section and you have the corridor dropping templates which are at different stations than these cross sections, there is interpolation/stroking between the templates.&nbsp; This can cause the corridor to appear at incorrect elevations, but it is just the stroking from the template drops.&nbsp;</p> <p>You should check to make sure the templates are getting dropped at the exact stations that the cross sections are created.&nbsp; You can alter the template drop multiplier or the template drop interval so it will drop the templates more to get a better model.</p><div style="clear:both;"></div>