Hello,
While doing Vertical Profile from Quick Alignment, I get the error "G String not suitable for Quick Alignment" (Screenshot attached) and I am unable to proceed. Will someone explain about this ?. Actually someone had done Horizontal and Vertical alignment by Element Method and I wish to quickly modify using the Quick alignment method as I am more familiar with it.
Do you have a curve that goes through more than 180 degrees? That is not possible to do in IP method i.e. Quick Alignment. You should use ALIGNMENT, as it is more flexible than QA.
Hello Amita,
I dont think that there is a curve to curve section without any straight as you mentioned. Attached link has the Design and Triangulation GENIO. Please check at your end and let me know. I have faced this issue many times.
https://www.dropbox.com/sh/fg3c5asw8odz07h/AADyg90eyqx4gtvclpOdHGRja?dl=0
Hello Deepak,
From the image looks like you have a curve to curve section, quick alignment does not support such alignments. If this is not the case, please send across the dataset.
Hello Dipak,
Thank you for posting your question on Bentley Forum.
Please refer below the links for your reference.
https://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki/26997/g-string-is-not-suitable-for-quick-alignment
https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/86672/problem-in-quick-alignment
Regards,
Purva Lakde