Is there any way (Keyin, dialog, other) to give a data point at zero offset, profile grade elevation?
Yes, I am aware of the SE= precision keyin. I have to know the profile grade elevation already in order to use that.
I am hoping (against hope!) that there is some way to get the profile grade elevation for a known station while in that cross section(!) and use it to place an element.
Geopak had a great tool for this, but I am, unfortunately, no longer working in Geopak. Does InRoads have anything I can use like that?
MaryBPower Inroads 08.11.07.615
yet bet. I used the tracking and notes all the time.
That's the most concise solution yet. Thank you.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
Yes, If you use the Horizontal Alignment tracking it is the active profile. I also like setting up an InRoads note using Station and Vertical Elevation.
Are you sure the elevation is the Profile and not the active surface?
Set the alignment active. In Plan view use the tracking tool. Tools>Tracking>Horizontal Alignments. Snap to the object and the readout will give you station, offset, grade, elevation. (the grade and the elevation values correspond to the active profile). If you don't have an object to snap to, draw a line or place a cell with the command so= (station,offset).
Answer Verified By: MaryB