Hi,
I have several alignments in a coordinate system (SYS34 for Denmark) and I need to change it to another coordinate system (DKTM3 for Denmark), but when I do that the alignment is not completely moved and it looks funny as seen in the picture that I attached.
Where does it go wrong or why?
I am using PowerCivil for Denmark (SS4) v8.11.9.833
So from your other post, you said you get this "bad" result for other alignments, but not plain MicroStation elements. You can reproject plain "dead" graphics, but when you try to reproject alignments to this new coordinate system, you get the issues shown above.
Can you reproject from SYS34 for Denmark to any other coordinate system successfully?Can you reproject to DKTM3 for Denmark from any other coordinate system successfully?
I don't know much about reprojections (honestly) but that might help narrow down if it's a problem with the coordinate systems, or with the civil geometry.Hopefully, the folks with more knowledge than I will be along to help you further.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2