Why end area volume report is blank?

RE: Why end area volume report is blank?

tforsman — Mon, 25 Feb 2019 19:50:09 GMT

Thanks, that got me close. I opened Project Explorer under Feature Def. /Design, I then had to go to properties of each component and set volume to existing. Then created Cross Sections again and the End Volume Report worked.

RE: Why end area volume report is blank?

Chris Key — Mon, 25 Feb 2019 13:50:24 GMT

Yes, this is typically a result of not having a design surface and an existing surface. My suggestion would be to change the property on the Existing Terrain so it is an 'Existing' type and then cut a new set of cross sections. The cross sections will not update with property changes and that information is likely tagged on the terrain graphic in the section model.

https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/142564/updating-existing-cross-sections

RE: Why end area volume report is blank?

tforsman — Fri, 22 Feb 2019 22:31:24 GMT

I think it's my EG existing surface is type "none", but when I go into the preferences of my EG its type is existing. How do I get the report to recognize that change? Or is it my cross sections that have the EG type "none" stuck when I created those?

It feels like I should delete everything and start over.

RE: Why end area volume report is blank?

tforsman — Fri, 22 Feb 2019 21:21:57 GMT

Is there much difference between the CUT and FILL of End area volume and Component quantities volume?