When I use the Milling Report tool, my stationing is all wrong. I found this article from Chris Key and copied the new report but the stations are even worse. The true start station in my model is 555+91.90 but the imperial report station is 8+38.95 (see below), the report that came with the software shows a station of 575+05.40?? Both reports are wrong.
Hi Chuck,
This issue was previously elevated to our Development group as Defect 804759 - Milling Report internal and external stations are incorrect.
Regards,
Sanders
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Answer Verified By: Chuck K.
Sanders, has this issue been resolved yet?
Jennifer Perry
Highway Design | Johnson, Mirmiran & Thompson, Inc.