GEOPAK - Unable to save profile - Chain not found

I am using the profile generator.  I opened up a profile that I previously stored.  I would like to change it, but when I try to save it I am told "Chain B not found."  This profile is named BPRO1 and it is based on a chain named B.  Navigator shows this chain to exist and I can describe it, obtain sta/off using the labeler, etc., etc.  How was I able to store this chain once, but not anymore?  I would like to save it as BPRO2 as a backup and then modify BPRO1, but I can't "save as" either.  The MicroStation status window keeps telling me that "Chain B not found."  Redefine is on by the way.

Josh Mauritz
MS v08.11.05.17
GPK v08.11.05.39

Parents
  • I also had this problem but deleteing resources didn't work.

    I had a profile cell that had a reference station set to 6+00 and the actual chain it was defined with started at 9+60.  When I trying to save a profile as.... I got the Chain XX not found error.  Changing the reference station  to 9+60 within the profile cell settings was able to resolve the problem.

     HTH

    MS 08.09.04.88

    GPK  08.09.06.31

Reply
  • I also had this problem but deleteing resources didn't work.

    I had a profile cell that had a reference station set to 6+00 and the actual chain it was defined with started at 9+60.  When I trying to save a profile as.... I got the Chain XX not found error.  Changing the reference station  to 9+60 within the profile cell settings was able to resolve the problem.

     HTH

    MS 08.09.04.88

    GPK  08.09.06.31

Children
No Data