Hello all,
I installed the current version of InRoads (ir81109918en.exe) on top of my MicroStation V8i SS4 V08.11.09.862 running on a Workstation with Microsoft Windows 10. The Installation of InRodas works fine and finished without any error message.
When I have started Inroads the first time, I 've received a .net error. I eliminate it by commenting out the line with "InRoads_SS4=1" in file "InRoads.3.1.cfg" as suggested in https://communities.bentley.com/products/road___site_design/
After that MicroStation starts but in the end of loading a dgn a error message "Failed to load INROADS.3.1.DLL" appears. The new microstation menue entry "Application" is empty.
Can someone help me with this Problem? What's going wrong with the Installation?
Regards,
Daniel
Hi Marc,
I need InRoads for our MicroStation V8i SS4 Environment. Therefore I've downloaded and used this InRoads-installer. Was it wrong?
Regards
Hi Daniel, InRoads SS10 version 08.11.09.918 won't work with your version SS4 of MicroStation, you need to have MicroStation SS10.
I think you're confusing Windows 10 with Ss10. Ss10 is a special version of V8i to use Connect Licencing and Windows 10 certification.
When running inRoads Ss2 or Ss4, you need MicroStation Ss2 or 3. You may be running to new a version of MicroStation.
Charles (Chuck) Rheault CADD Manager
MDOT State Highway Administration
Hi cadcop, not sure if your comment is addressed to me or Daniel?
A little of both. Daniel never mentioned Ss10, only Windows 10. But I also know there were certain MicroStation V8i that we’re for certain verticals and we’re not recommended for the Civil vertical platforms. We started using Power InRoads instead of InRoads with MicroStation and are using Windows 10. But because we launch a single program, we have not had Daniels problem.