Integrate Autoturn to OpenRoads

Hi Martin,

Heres some info I posted in the MicroStation forum a while back (its also valid for ORD):

https://communities.bentley.com/products/microstation/f/microstation-forum/174122/launching-autoturn-in-connect

Thank you Mark for sharing the steps!

In my case, I was able to load the AutoTurn and I can see it in the Drawing workflow, however, nothing happens when I click on the AutoTurn icons. In left lower corner says Ambiguous Command when I try to activate anything. Any thoughts? 

I use AutoTurn 11 and ORD 2021 First Release.

Regards,

Jovan

Hi Jovan,

This usually happens when you have more than one add-in that has the same command so perhaps you have autoturn 10 and 11 loaded at the same time?

Hi Mark, I have the same issue as Jovan. Using AutoTURN 11 and OpenRoads 2021 Release 1. Nothing happens when clicking on the icon, and I only have AutoTURN running on my laptop.

Hi Mark, I have the same issue as Jovan. Using AutoTURN 11 and OpenRoads 2021 Release 1. Nothing happens when clicking on the icon, and I only have AutoTURN running on my laptop.