ORD > SUDA - Reconnect pressure line end does not work.

Specific Example:

  1. You have two water lines which were created independently and in the real world are supposed to be part of the same system.
  2. But during survey, layout, design, whatever a small gap existed between the two lines so now there two nodes where there should be a shared node.
  3. Expected solution is to select one of the lines, reconnect the end point to the common node and delete the extra node.
  4. This does not work.

Note that it is not sufficient to just put the two nodes atop each other, because unless the lines have a common node, a profile run cannot be created.

Parents Reply Children
No Data