I have an alignment with a profile that came from an ALG. The profile is effectively a profile from surface created in the ALG before import. I'm trying to use the best fit profile tool to create a new profile that is always above the exiting profile, but some sections had a raised median. To modify my source profile, I've used the Profile Offset Transition tool to create a "sub-profile" to create a lower section where the median areas are. Now, I need to open up two intervals on the original profile so I can complex all these pieces together and finally generate the best fit profile.
But I can't seem to find any tool that allows me to create the interval. Partial delete seems to do nothing. Trim multiple looks promising, but I need to open one interval in the middle, the other interval really needs to go from a certain point to the end of the profile - in effect, cutting it off for the last few hundred feet, leaving nothing of the original profile beyond the start of the interval.
I tried dropping the elements hoping I could work with simple MicroStation graphics, but that just made them disappear completely.
I must admit that I am finding working with Civil Geometry to still be fraught with frustration as seemingly simple workflows turn into frustrating efforts in futility.
As I was finishing this up, confirming that everything I am reporting is accurate, I crashed ORD. When I reopened the file and profile model, I actually had my intervals and was able to run my best fit.
Now, in InRoads, at this point, I would use the Vertical Elements tools to see where I could replace multiple short curves with a single longer curve. My efforts to replicate this are not working. I tried the Profile Curve Between Elements tool - the Parabola between and the profile curve between modes. it neither opened an interval nor did it trim or extend. So Now, I'm back to manually opening an interval, which may work, if I crash out of the product, or may just raise my blood pressure.
And even if I get it to work, making edits to curve lengths and modifying PI's is neither intuitive nor as simple as the tools of InRoads.
Hear! Hear!
Geometry edits are perhaps the most frustrating tasks in OpenRoads. The developers don't seem to be aware that geometric design is an iterative process so haven't provided appropriate tools or workflows to do this type of work. The Horizontal/Vertical Elements tools from InRoads are invaluable in building and editing geometry. The curve editor allows creation of a compound curve with combining spiral in one step, fancy that!