Good Morning,
As a result of some file restoration, it appears that my Superelevation Section has lost its association with the horizontal geometry from which it was created. This appears to be preventing it from applying to the corridor properly. Is there a tool similar to the "Reattach Corridor" Tool to restore the Superelevation Section association from its horizontal alignment?
Thanks in advance as always!
Does the superelevation have association with any horizontal alignment? If so, and you want to swap that to a new alignment the key in "geometry element replace" will do this....among other things. So user beware. This key in will replace all referencing geometry from one element to another.
I will definitely take a look at this. Thanks for the heads up!
I tried this and the response was that the superelevation section was not valid for the tool. Good to keep in mind though. Thanks again for the feedback!
Robert,
When using this tool you do not pick the superelevation object, you pick the old centerline and then replace it with the new.