Have been trying to create double plan view and a single profile view for the all day but i failed i want a double plan views and full profile that has covers the length of those two plans.
Please help
I am only a casual InRoads user - my question would be - if you have created 2 plan views, how is the profile to know what the start/end chainages are in each plan view, so that it can make one continuous profile? What says that the plans views are side by side? What happens if there is an overlap in plan views?
Is what you are trying even possible?
The plan views overlapped but i shifted the other plan view to the right on the sheet view.am asking if u can create fa profile itself a length that resembles those 2 plan views' length and automatically run the plan and profile generator that combine the plan and profile and the that has 2 plan views and 1 profile is that possible cause have seen it on a certain design that was done by inroads.
If you "have seen it on a certain design that was done by inroads" it must therefore be possible, but I am afraid I am unable to tell you how.
Then i guess i should re-post this again may be someone else knows.
No need to re-post. This thread is not yet answered, and another post would be just confusing.