Hello, i have three little questions about OpenRoads.
1.The workflow of the progect i was working on, was set active as OpenRoads Modeling. To try something, i switched it to "Drawing" and i can not take it back to "OpenRoads Modeling". How can i set the workflow as "Modeling" back ?
2. On my file, i set angle format at "Angle Readout" as gradians but while some of values show in gradians, some still does in DD MM SS format (as in the picture). How can i fix this ?
3. When i hand-calculate the cord length i find Xs=54,954 and Ys=1,680. So these values match with the program output in reports sections. But they seem different on the view. What may cause that ?
Your helps are very appreciated as i am a student and still learning this program.
Have you enabled tasks and task navigation? There has been a bug (or something more sinister) since ORD was rolled out, that when you enable task management, it breaks some of the workflows. A number of us reported this as a bug.
I've been beating that dead horse a long time and still found it not "fixed" in the most recent version.
The last time I tested, I was able to load a task menu and initially, the OpenRoads Modeling workflow was active, but at some point, I changed the workflow and when I tried to change it back, it was gone. Disabling the Tasks Navigation capability restored the standard workflows on your next session.
Charles (Chuck) Rheault CADD Manager
MDOT State Highway Administration