Removing key station

RE: Removing key station

Nate Perius — Thu, 14 May 2020 13:50:57 GMT

I verified that the station in question is NOT at a horizontal or vertical cardinal point.

I changed my design stage to one that does not include critical sections at horizontal or vertical cardinal points and the model still calculates a cross section at the station in question.

RE: Removing key station

Nate Perius — Thu, 14 May 2020 13:28:33 GMT

If I understand your question correctly. No, the station in question is in the middle of the range the template drop is being used on.

RE: Removing key station

eddiegiese — Thu, 14 May 2020 12:25:28 GMT

It may happen be a horizontal or vertical cardinal point that is being calculated to properly adjust for, say, a change in grade. This could be controlled at the Corridor level by the Feature Definition/Design Stage you've selected. You can check this by drilling down to the Properties of the Feature Definition within Project Explorer in your DGN.

RE: Removing key station

Mark Marnell — Thu, 14 May 2020 09:50:42 GMT

Does it, by pure chance, happen to be where a template drop occurs?