Hi
I have problem with auto upgrade files from SS4.
I set CIVIL_UPGRADE_PROMPT_OFF =1, but old files (SS4) are always READ-ONLY. I have ORD 2020 R2.
In my company we have also ORD 2020 R1 where all works fine.
I also tried several combinations of these config variables but civil SS4 files always open as read-only. Perhaps this is an objects schema issue between SS4 and ORD 2020 R2 which doesn't allow for editing. I submitted a service request to Bentley.
I tested this in the following manner:
1. Create a new file in SS10 (or SS4)
2. Add a civil line using the horizontal geometry tools.
3. Now try and load this file in ORD 2020 R2 ( make sure to set CIVIL_UPGRADE_PROMPT_OFF = 1 )
I tried:
- define CIVIL_UPGRADE_PROMPT_OFF in Organization Standards
- define CIVIL_UPGRADE_PROMPT_OFF in WORKSPACE
- define CIVIL_UPGRADE_PROMPT_OFF in WORKSETS
- define CIVIL_UPGRADE_PROMPT_OFF in personal.UFC
- define CIVIL_UPGRADE_PROMPT_OFF with another value
CIVIL_OPEN_OLD_READONLY is undefined.
When CIVIL_UPGRADE_PROMPT_OFF is undefined I have message:
Regards
Patryk
What all have you tried so far to troubleshoot your issue? Have you tried leaving the CIVIL_UPGRADE_PROMPT_OFF variable undefined as a test to see what happens? Is the CIVIL_OPEN_OLD_READONLY variable defined?
Regards,
Jacob
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki