• State Not Answered
  • Replies 9 replies
  • Subscribers 149 subscribers
  • Views 1429 views
  • Users 0 members are here

QuantitiesReport tool BUGS

Zhengpeng Chen
Offline

Hi,

The latest OpenRaods Designer(2020 Release 3 Update9),

About the tool "Quantities Report By Named Boundary"  , check on the  "Display Clipped Graphics" box, then the Clipped graphics will be created.

But, to the Tunnel Model, The tool goes wrong! it only cuts the model, and forget to colse the model  void.

Hope to fix this bugs ASAP.

    

Thanks!

Chen Zhengpeng

Parents
  • 0 Offline

    I have the same result as you if i choose to clip only a part of the tunnel.  The quantity are good only the seeling of the mesh is bad.

    I have found a workaround to this: perform a mesh audit, it will create 4 linestrings at the edges of your mesh, create a region inside your linestring, then create a mesh with the region.  you will end up with something like this: 

    You should fill a service ticket

Reply
  • 0 Offline

    I have the same result as you if i choose to clip only a part of the tunnel.  The quantity are good only the seeling of the mesh is bad.

    I have found a workaround to this: perform a mesh audit, it will create 4 linestrings at the edges of your mesh, create a region inside your linestring, then create a mesh with the region.  you will end up with something like this: 

    You should fill a service ticket

Children
Communities
Support and Services
Training and Learning
Social Media