I created a template with logic to display different slopes in cut and fill from curb and gutter. I am using components rather than end conditions as shown below
It works for the most part, but at some point, I actually get what is shown below. Rather than sloping upward or to the right, it solves to the left and down. I am not sure why.
The fact that is sloping down does not allow my logic to work.
Has anyone come across something similar with "project surface" tool and been able to find the cause?
thanks,
Felix
I think you may need to have the "End condition is infinite" ticked on to allow it to continue to search for it until it hits your surface. See the picture below to see what I'm talking about.
Thank you for your feedback Yash, but it's not the route I am taking with template yet.
I might end up using end conditions in combination with components, but I am leaving it as my last option.
If I read that correctly, you are trying to ensure that your slope stays inside of a right of way line. There is a simple End Condition method that will do that for you, without display rules or mutliple logic tests.
What this following video - the example at 30 minutes is possibly what you want.
https://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki/17889/video-understanding-end-conditions