I used corridor clipping to remove the bridge portion from my corridor. I decided I wanted to remove the clip and put the bridge back. It is now saying I don't have a corridor clipping to remove and now my horizontal and vertical alignments are not attached to the corridor.
Is there a way to reattached my proposed ALG's to the corridor without redoing the corridor? I have super elevation, point control, end condition excepts, etc. all done and don't have time to restart.
I noticed this issue when I was trying to produce Plan & Profile sheets and realized I couldn't find an active profile to display.
It looks I did the same operation and in my case the corridor element is gone... What's left are template drops, template geometry, 3D lines and meshes. All dumb of course. A bit shocking.
Yes
Does the Alignment have an active Profile?
Regards,
Mark
OpenRoads Designer 2023 | Microstation 2023.1 | ProjectWise 2023
I tried the Reattach command and I don't see the profile showing up in the 3D or profile view.
OpenRoads Designer Connect Edition Release 2