I am struggling with the annotation in my cross section sheets. I have a lot of questions, listed below, if I can get answers to any one of them that would be greatly appreciated!
Here is a sample of my XS.
1. I have the same template drop for my corridor. EVERY segment for annotation is turned on without any expressions. On the right, notice between the two cross sections, one slope is annotated and the other is not. I can not determine why this is happening.
2. Larger scale, I don't understand why the material component is appearing in my cross section. Especially for the ditch - the template is being used on the left side of the roadway, and the material is NOT showing there. Why could this be happening?
3. Not pictured, but I can not get any annotation to appear when using surface templates. I'm trying the simple point annotation (station and offset), calling out the point names directly and they don't show. Is there a different annotation for this?
4. When writing expressions - I'm trying to get everything to annotation except for a specific segment. I don't understand how to call out that sement, i tried using NOT pointname1 = "EOP", but everything still appears. Am I doing something incorrectly with that?
5. What is the best way to identify the end points to be added to the annotation for point naming with Sta/Off. For example, my usual workflow is to view the dynamic cross section, select station edit and view the template it is using. But then I realize it is only calling out the one template used and not the corridor next to it. So I adjust for the ditch corridor, and add the specific point name to be annotated - but nothing shows up.
Any insight, even on proper workflows for annotating would be appreciated. I've spent a lot of time on different forums, and watching videos on Bentley sites - but nothing seems to address my issues.