Hi Everyone,
Our firm is having a recurring problem with our cross section labeling. We are creating our cross sections from corridor models. Once we have the cross sections cut, we only have 50-75% of the necessary cross hairs populated to annotate the cross sections. There is no rhyme or reason that we can pinpoint as to why it creates the cross hairs in some locations and not others. For example on one project, both edge of pavements were the same feature definition, and one side generated cross hairs and the other did not. We have tried changing the feature definitions, changing the point naming conventions, and even tried creating our own feature definitions to no avail.
It is starting to get frustrating to continually have to hand edit half of our cross sections.
Any help would be appreciated!
Thanks!
The following video will help you to guide on few troubleshooting technics for cross-section annotation issues, please check out the video ,
https://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki/52474/cross-section-point-annotation-troubleshooting
As well as there is similar short video also guide you on this issue , find link below,
https://www.youtube.com/watch?v=cA-pu-DfcdI
Avdhoot
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Thanks for the response. The version that we are using looks a little different than the information provided. We don't have those tools. For example, this is what the tool boxes look like that we have.
What software are you using? It is some v8i release of InRoads/GEOPAK/MX, not OpenRoads Designer.
It is V8I SS4 with GeoPAK, but I don't know where to tell if it is Open Roads or In Roads. If this is the wrong section of the forum, which one should i post my question in? This was the one that i thought was closest.
You are in the right forum - GEOPAK SS4 with OpenRoads Technology is your situation :-) I have never used GEOPAK so cannot answer, sorry!