This discussion should help: https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/178764/skewed-cross-sections-in-openroads-designer

Unfortunately not, I’m not looking to make a drawing but to connect 2 different corridors in a diagonal. Sorry I did not make that clear in my question :-)

Hi Sarah, create a closed shape at the end of the corridor that you want to cut and add as a Corridor Clipping element to your corridor.

Please note that clipping will only be applied to your 3d model, but thats all you should need.

Thank you, this was very helpful :-)

Hi Sarah,

Does that work, if yes can you drop some steps for it ?

Hello,

Yes, it did work, below is my notes from 2 years ago.  

For non-equal intersections between 2 templates, do the following

• Draw smart line figure around the area that must be removed
• Tab Corridor --> Miscellaneous --> Corridor references --> Corridor clipping
  • Do this for both templates, in the 2D view this cannot be seen, but in the 3D view the 2 templates intersect each other based on the drawn smart line figure.

Hope this helps, my notes are almost 2 years old, so hope it is still done in the same way. I haven’t done it myself since this project.

Hello,

Yes, it did work, below is my notes from 2 years ago.  

For non-equal intersections between 2 templates, do the following

• Draw smart line figure around the area that must be removed
• Tab Corridor --> Miscellaneous --> Corridor references --> Corridor clipping
  • Do this for both templates, in the 2D view this cannot be seen, but in the 3D view the 2 templates intersect each other based on the drawn smart line figure.

Hope this helps, my notes are almost 2 years old, so hope it is still done in the same way. I haven’t done it myself since this project.

Thank you

This recent video shows using this tool.

www.youtube.com/watch

I tried to attached a link but it was labeled abusive.  If you look on youtube on Bentley OpenRoads channel and go to the video 

Answer Hour January 2023: 05 - Bridge Abutment Embankment Design Around the End or Edge of Corridor

it shows this tool in use.

thanks Lucas, appreciable!