Hello
I have a question regarding the corridor. I have tried to find the answer, but I can’t, so maybe you can help.
The question is if it is possible to make a diagonal cut in the corridor and if so, how?
The diagonal cut is going to be the big black line in the yellow shape, in the photo down below.
This discussion should help: https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/178764/skewed-cross-sections-in-openroads-designer
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
Unfortunately not, I’m not looking to make a drawing but to connect 2 different corridors in a diagonal. Sorry I did not make that clear in my question :-)
Hello,
Yes, it did work, below is my notes from 2 years ago.
For non-equal intersections between 2 templates, do the following
Hope this helps, my notes are almost 2 years old, so hope it is still done in the same way. I haven’t done it myself since this project.
Thank you
This recent video shows using this tool.
www.youtube.com/watch
I tried to attached a link but it was labeled abusive. If you look on youtube on Bentley OpenRoads channel and go to the video
it shows this tool in use.
thanks Lucas, appreciable!