Diagonal cut of corridor

RE: Diagonal cut of corridor

Amrat Mishra — Sun, 26 Mar 2023 07:39:07 GMT

thanks Lucas, appreciable!

RE: Diagonal cut of corridor

Lucas Hicks — Fri, 24 Mar 2023 19:12:26 GMT

I tried to attached a link but it was labeled abusive. If you look on youtube on Bentley OpenRoads channel and go to the video

Answer Hour January 2023: 05 - Bridge Abutment Embankment Design Around the End or Edge of Corridor

it shows this tool in use.

RE: Diagonal cut of corridor

Lucas Hicks — Fri, 24 Mar 2023 19:08:17 GMT

This recent video shows using this tool.

www.youtube.com/watch

RE: Diagonal cut of corridor

Amrat Mishra — Fri, 24 Mar 2023 12:09:56 GMT

Thank you

RE: Diagonal cut of corridor

Sarah Provstgaard — Fri, 24 Mar 2023 12:03:36 GMT

Hello,

Yes, it did work, below is my notes from 2 years ago.

For non-equal intersections between 2 templates, do the following

Draw smart line figure around the area that must be removed
Tab Corridor --> Miscellaneous --> Corridor references --> Corridor clipping
- Do this for both templates, in the 2D view this cannot be seen, but in the 3D view the 2 templates intersect each other based on the drawn smart line figure.

Hope this helps, my notes are almost 2 years old, so hope it is still done in the same way. I haven’t done it myself since this project.

RE: Diagonal cut of corridor

Amrat Mishra — Fri, 24 Mar 2023 11:49:38 GMT

Hi Sarah,

Does that work, if yes can you drop some steps for it ?

RE: Diagonal cut of corridor

Sarah Provstgaard — Tue, 18 May 2021 08:22:14 GMT

Thank you, this was very helpful :-)

RE: Diagonal cut of corridor

Mark Shamoun — Mon, 17 May 2021 13:28:38 GMT

Hi Sarah, create a closed shape at the end of the corridor that you want to cut and add as a Corridor Clipping element to your corridor.

Please note that clipping will only be applied to your 3d model, but thats all you should need.

RE: Diagonal cut of corridor

Sarah Provstgaard — Mon, 17 May 2021 13:13:54 GMT

Unfortunately not, I’m not looking to make a drawing but to connect 2 different corridors in a diagonal. Sorry I did not make that clear in my question :-)

RE: Diagonal cut of corridor

MaryB — Mon, 17 May 2021 12:59:16 GMT

This discussion should help: https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/178764/skewed-cross-sections-in-openroads-designer