Hey,
Has anyone else ran into this problem? I'm using the same cross section annotation on every one of my models, and sometimes the EAV table populates and other times the EAV table does not populate on the cross section. It will be along the same alignment, same model file, just sometimes the EAV table shows up and other times it does not.
Update: this appears to be happening for surface templates and linear templates. It works fine with a corridor - is there something specific that I have to do to my surface templates for it to reference the alignment?
Any suggestions?
Have you taken fresh cross sections since you ran the EAV report, by any chance? Is it the same cross sections that do not get annotated?
Yes recut sheets, and yes it is the same cross sections that do not get annotated.
OK - I would think that the Named Boundary has not got the XML fragment required from the EAV report, as you have recut the sections (but possibly not rerun the report).
Select one of the cross section Named Boundaries and check its Properties - does it have the 'End Area Volume Xml Fragment'? If not, you will need to rerun the EAV report to fill this 'property'.