Yesterday I worked in a cross section model and annotated it. Yesterday, my only issue was that my Cross section Navigator didn't work. The error below appears.
-the cross section cell was in place and i am in the correct gpk
Today when I went to the Cross Section Model, but the model does not appear on the Cross section window.
-the name has not been changed.
-the model has not been deleted; I can still see and edit the cross section model.
Do anyone know why my model isn't appearing anymore? and Why my navigator isn't working?
(This was a similar question from 3 years ago here but I didn't see any resolution)
Hello Taylor,
May I know which product and its version you're facing this issue with?
For more information about the Road and Site design tools, visit the Road and Site design WIKI at: http://communities.bentley.com/products/road___site_design/w/road_and_site_design__wiki
Are your geopak cells referenced or active in the dgn you're working in? If they are not active, try activating that reference temporarily, then running the navigator.... or copying in a copy of the cells. Otherwise, were the cells you're using created by you or someone else?
Bentley Accredited Road Designer | Bentley Accredited Road Modeler
colliersengineering.com
I cut this cross sections. The cell is active in the the dgn. I tried coping in a cell that works in a different model and than using the navigator but it gave me the same error message.
At this point it shouldn't be an issue but...Are all of your cross sections and cross section cells in positive coordinates ("up & right" of 0,0)?
I have seen strange behavior when any of my section work drifted into negative coordinates.
MaryB
Power GeoPak 08.11.09.918Power InRoads 08.11.09.918OpenRoads Designer 2021 R2
It is in positive coordinate system. Thanks for pointing that out, that will be another check I'll do when creating Cross sections.