I am having an issue with slopes in cross sections after an upgrade to ORD 2021 R1.
The screenshot below shows that I have created a linear annotation definition for slopes and for the target criteria I have identified one component of the template used for the corridor as the slope I want to label. The expression is emply as I am identifying just one piece to label.
However, what is labeled in the drawing model is the entire top surface of the corridor. I am not sure what is controlling this but in the past if you identified just certain pieces of the template to label slopes the 10.09 software would only label just those slopes. See the screenshot below.
I appreciate any guidance on this issue.
ORD 10.10.01.03 (2021 R1)
I've seen some issues with the filter in this release. There's been extensive work done on XS filter and annotation in the 2021R2 build. As a test, I'd advise installing it to see if the filter works correctly.
For more information about the Road and Site design tools, visit the Road and Site design WIKI at:
Answer Verified By: Sean Keene
Thanks Marcus, I can confirm that installing the 2021 R2 build fixed the issue.