Are there any good training videos on as to where it shows how to set up the point control on making templates (specifically the end conditions) as to where it ties to the existing pavement from the topo file given?

Question

I would like to set up my templates using ORD (open roads designer) for the end conditions to tie into the existing pavement on the topo file.

Mark Shamoun · Accepted Answer

Try looking here: 
 Find Training (bentley.com)

Christina Go · Answer

I figured it out through training thanks 
 In order to tie existing pavement to corridor 
 Corridor > Edits > create point control > add start and end station > click on the corridor point you'd like to control > click the point you'd like to tie into 
 
 Video on where it goes into more detail via Bentley Training as mentioned from commenters: 
 QuickStart for Corridor Modeling - Road 
 Modify the Corridor

Are there any good training videos on as to where it shows how to set up the point control on making templates (specifically the end conditions) as to where it ties to the existing pavement from the topo file given?

Top Replies