https://communities.bentley.com/products/road___site_design/f/geopak-inroads-mx-openroads-forum/231377/point-controlI am not able to select the corridor even though it is present in the attachments. And when i am assigning it , it is showing that it causes a recursive solution even though it is a different corridor.en-USTelligent Community 12https://communities.bentley.com/thread/717236?ContentTypeID=1Fri, 17 Jun 2022 14:33:06 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:e1d7084b-2852-4ab6-b6ea-2f7d29177debMaryB<p>It&#39;s possible that features in one corridor have been used to create another corridor. Even though they are separate corridors, they could develop a recursive relationship.</p><div style="clear:both;"></div>https://communities.bentley.com/thread/717122?ContentTypeID=1Fri, 17 Jun 2022 07:22:53 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:cb1dc4f9-767b-45e5-b98e-99d912e5302aGP<p>It is not working , the issue is that i have a corridor and i am trying to apply a point control by using the corridor feature of another corridor , and it is keeps showing an error that it is a recursive solution.</p><div style="clear:both;"></div>https://communities.bentley.com/thread/717085?ContentTypeID=1Fri, 17 Jun 2022 05:25:54 GMT6dad98f5-dbc9-4c4d-a9ba-e9da8dc6aa8e:ca5d3b72-dd13-42d0-884e-abb8d0098e86Paul Cusack<p>OpenRoads will not allow a point control to be added to a corridor if the software identifies the geometry of the point control to be dependent on the corridor graphics/geometry. Perhaps that is what you are describing? If so, then removing the point control&#39;s geometric dependency on the corridor will allow it to be used as a point control in the corridor.</p><div style="clear:both;"></div>