Components Not Displaying in Corridor

RE: Components Not Displaying in Corridor

caddcop — Tue, 19 Jul 2022 03:15:59 GMT

Exactly. We use a -LT and -RT suffix for point names and component names. We also add a -M for a median component or point that also has an outside complement. And a -F or -B for Front and Back for things like sidewalk edges. Sequence numbers are for the birds. It's hard to get consistent breaklines with sequence numbers. A tight naming convention makes transitions easier and modeling a smoother process.

RE: Components Not Displaying in Corridor

Jean Mouton — Mon, 18 Jul 2022 21:39:59 GMT

That did it! Thanks! So I'm guessing I need to name components on each side of the road differently, i.e. "left surface", "right surface", etc.?

RE: Components Not Displaying in Corridor

Marc Bachand — Thu, 14 Jul 2022 11:19:11 GMT

Check to see if you have component name over rides defined for all your components. If so, try and remove them and sync the corridor template with the ITL.

Marc

RE: Components Not Displaying in Corridor

Jean Mouton — Wed, 13 Jul 2022 22:01:35 GMT

Here is the .itl file. Though based on the KYTC template library, the template in question is called "Access Road".

communities.bentley.com/.../Access-Road.itl

RE: Components Not Displaying in Corridor

MaryB — Wed, 13 Jul 2022 20:43:07 GMT

To the eyeball, that looks fine.

If you could post your template, someone may be able to dig into it to see what exactly might be different from the left to the right side.

You can always file a Service Ticket with Bentley Support as well.

RE: Components Not Displaying in Corridor

Jean Mouton — Wed, 13 Jul 2022 20:16:31 GMT

Thanks for responding. I haven't solved the problem yet, but I can say the corridor does produce proposed contours normally. Here is the overall and a zoomed in view:

RE: Components Not Displaying in Corridor

MaryB — Wed, 13 Jul 2022 20:04:21 GMT

What does your template look like?