Components Not Displaying in Corridor

Exactly. We use a -LT and -RT suffix for point names and component names. We also add a -M for a median component or point that also has an outside complement. And a -F or -B for Front and Back for things like sidewalk edges. Sequence numbers are for the birds. It's hard to get consistent breaklines with sequence numbers. A tight naming convention makes transitions easier and modeling a smoother process. 

That did it! Thanks! So I'm guessing I need to name components on each side of the road differently, i.e. "left surface", "right surface", etc.?

Check to see if you have component name over rides defined for all your components.  If so, try and remove them and sync the corridor template with the ITL.

Marc

Here is the .itl file. Though based on the KYTC template library, the template in question is called "Access Road".

Access Road.itl

To the eyeball, that looks fine.

If you could post your template, someone may be able to dig into it to see what exactly might be different from the left to the right side.

You can always file a Service Ticket with Bentley Support as well.