Hello everyone,
I have created a corridor with a simple template.
When selecting different components from the 3D view, I don't always get the volume property in the civil quantities tab (see the images below for reference).
Do you have any idea what could be the issue ?
Regards,
Hi Youssef,
I'm not sure if you have resolved this issue, but we have found that if a component width is less than a certain ratio its linear length the Civil Volume will not be reported. The ratio we have found is approximately 0.3mm width per linear metre, so based on your component length of 7921m only components a min width of around 2.4m in your corridor will report Civil Volumes.
This is still an issue in 2022 R1 so the only option you may have is to break the corridor into smaller parts, around 3km in length.
Mark
OpenRoads Designer 2022 R3 (10.12) | Microstation 2023 | ProjectWise CE 3.4
Your analysis is quite shrewd, Mark. I have noticed the same issue but have not seen a ratio applied to it. Thanks so much!
Best Regards,
haha i did go a bit far trying to find a pattern for it. I am unsure why there is anything linking this component volume value to the linear length (as it isnt necessary), however the pattern cannot be coincidental.
also we logged SR and finally defect was filled that whenever component thickness is less than 4 cm, it returns no volume as mesh. Eg we use 4 cm thick wearing course and it has no volume when using template either in corridor or in surface template.