other than pipe size-specific linestyles, we don't have two or three lines in 2D for pipes yet, right?
Ditto. We had started working on VBA Code that would modify the 2D feature to read the drainage property and replace the default symbology with an appropriate linestyle. But I lost access to the programmer due to the contract expiring so that's currently dead in the water and I am not even sure where the code even exists.
Let me add a question: When a pipe is resized, do end sections or endwalls also update to the correct size needed to match the pipes?
Charles (Chuck) Rheault CADD Manager
MDOT State Highway Administration
Chuck:
To answer your inquiry, no, the end section nodes do not update (nor do any nodes).
Best Regards,
Mark