How to break / trim the alignment without losing profile?

Question

Good morning, 
 
 Hi, I have an alignment with station from 0+000 to 10+000, and I also created profile for this alignment also. 
 Now I only need the alignment with station from 0+000 to 3+000 and I want to delete the station from 3+000 to 10+000. 
 How can I do that without losing the created profile from 0+000 to 3+000? 
 I'm using OpenRoads Designer CONNECT Edition - 2020 Release 3 - Version 10.14.04.04 
 
 Thank you very much. 
 --------------------------------------------------- 
 Parker 
 OpenRoads Designer CONNECT Edition - 2020 Release 3 - Version 10.14.04.04

Marc Bachand · Accepted Answer

Depending on dependencies you can use the MicroStation Delete vertex command to delete components from a complex while maintaining the original complex. Start at the ending element and snap to the end point with this tool. Then continue downstation. 
 Marc

Paul Cusack · Answer

If the alignment has no dependencies then it may be easier to create a new alignment by using single offset partial from 0 - 3000 and then copy the vertical. If the alignment has dependencies then the element ID must remain the same so I would look towards tools like Geometry Builder Edit & Delete vertex to remove PI's between 3000-10000.

Rohith M · Answer

In continuation with Paul's suggestion, please refer to the following link which reflects the first method: 
 Demonstration Video

How to break / trim the alignment without losing profile?

Top Replies