Guiderail point placed in template, not showing up in 3D model

Question

Good afternoon, 
 I've placed a template point for guiderail in my roadway template, and set the feature definition of the template point to what I believe to be the correct feature: Linear/Template Points/Guardrail and Barrier/TL_Guardrail_Single_Sided_R. 
 In the Dynamic Sections view, the guiderail appears. However, in the 3D model, only a line along my hinge point appears in the model, corresponding to where that template point is. The 3D guiderail does not show up. 
 Attached are screenshots of the library feature definition and feature symbology properties for the guardrail point. I think it all looks correct? 
 Any help would be much appreciated! 
 Thank you, 
 Larry

Marcus Blake · Answer

Try setting "create template geometry" to true.

Marcus Blake · Answer

Open the dgn that contains the corridor 
 Open Explorer>OpenRoads Standards>Feature Definition>Corridor 
 Toggle "linear features display" to true

**afterwards you might need to reprocess the corridor

Marcus Blake · Answer

If create horizontal geometry then assign an active profile to it with the same guardrail feature definition does the linestyle appear in the 3D model? 
 As a test you might also change the feature definition on the template point to something else to see if the corridor 3D feature updates. If it does change, then modify the f eature definition on the template point back to guardrail. 
 I'd also check that all your levels are on in the 3D model.

Jan Blaasse · Answer

The 3D Element Template is set to Default. That should point to your 3D linestyle.

Jan Blaasse · Answer

To show a 3D linestyle in the model, you need to define what line to show. The setting for this is in the 3D Element Template. I marked the area in your screenshot. 
 
 As an example a screenshot from our own workspace settings showing the guardrail symbology.