Good morning,
I have an area in my corridor where I go from a 2:1 fill embankment to a retaining wall in fill condition. I have created created grading to wrap the fill slope from the 2:1 embankment to the retaining wall, following similar steps to what's shown in this video for grading around bridge abutments. Session 5 - Grading Design and Modeling at Bridge Abutments - YouTube
However, when I create the proposed contours for this area, the contours do not follow the grading in this area. Rather than be draped along the grading, they come off and kind of float out in space a bit as they head towards the retaining wall. Please see the attached images.
I then tried adding a breakline connecting from the down to the bottom along the edge of the fill line. That made it a little better, but still not correct (plus I'm not even sure if that's the "proper" way to do it).
See the photo below (I changed the attributes to wireframe so the contours can be viewed, as they were slightly under the grass component and hidden)
Rather than stopping at the breakline, the contours then continue along the wall, and then try to come back up to meet up with the roadway contours or something?
Any help/tips would be much appreciated!