Reference files do not appear in OPR

Hello Kent,

I would like to mention sometimes this issue might occur is due to a 2D Model is attached to a 3D Sheet Model. Can you please check Z value which is assigned to the reference as if this Z value is too large, the reference may not display ?

This could also occur when attaching a 2D Model to a 3D Design Model.

You can also try the following: 

1.Create a new 2D Sheet Model

2.Attach the reference to the new 2D Sheet Model and Fit the View. 

You can also check this Z value as shown in the attached snapshot. If this Z value is large, change it to a smaller value or Zero and Fit View.

If still issue is persisting then I would suggest you to please first upgrade all your reference files to a version of OpenRoads Designer which you are currently working and then after attached as a references.

https://communities.bentley.com/products/microstation/w/microstation__wiki/10731/reference-not-displayed

Regards,

Purva Lakde

Hello Kent,

I would like to mention sometimes this issue might occur is due to a 2D Model is attached to a 3D Sheet Model. Can you please check Z value which is assigned to the reference as if this Z value is too large, the reference may not display ?

This could also occur when attaching a 2D Model to a 3D Design Model.

You can also try the following: 

1.Create a new 2D Sheet Model

2.Attach the reference to the new 2D Sheet Model and Fit the View. 

You can also check this Z value as shown in the attached snapshot. If this Z value is large, change it to a smaller value or Zero and Fit View.

If still issue is persisting then I would suggest you to please first upgrade all your reference files to a version of OpenRoads Designer which you are currently working and then after attached as a references.

https://communities.bentley.com/products/microstation/w/microstation__wiki/10731/reference-not-displayed

Regards,

Purva Lakde