i am doing a project that includes widening and milling and resurfacing of the existing travel way. i created a corridor model and template for these components but when i try to calculate the quantities using the corridor report and using the create end area volumes. the cut volume is showing underneath the milling limits with the milling depth. not sure how to go about this issue.
Hello, check your template component for milling. make sure it says "PavementOverlayFC/SC" and NOT "PavementAsphaltFC/SC"
from there you can confirm through project explorer under:
openroadsstandards/model file/featuredefinitions/mesh/XS/...PavementOverlayFC/SC
In the properties for those definitions..Volumeoption should say NONE instead of Design or something else.
Hope this helps.
Best,
Josue