Hello All,
I started my drainage model by placing the network without adjusting any of the conduit inverts. However, when I want to change an invert whether it is the upstream or downstream invert, it does not change and will change back to the original elevation it had. Both stop and end inverts are set to True, so I am not sure why they are not wanting to adjust. Any insight on how I can go about changing my invert elevations would be helpful. Thank you, very much appreciated.
Valerie Alanis
check properties for the pipes. "Set Invert to Start" and "Set Invert to Stop". If these are true then the pipe will always match the invert of the node to which it is connected. In order to manually override the pipe invert first set to False, then enter the new invert.
Related properties are:
Robert Garrett Senior Consultant
www.envisioncad.com
Answer Verified By: Valerie Alanis
I set both inverts, the start and stop to false and they did get resolved, thanks Robert!