Hello,
I am trying to replace an existing horizontal alignment with a new horizontal alignment that is an offset of a third element. The original horizontal alignment already has vertical geometry and a corridor associated with it. I have already tried the append element and complex redefine tools to no avail, as well as the key-in geometry element replace. I was unable to use the keyin Geometry Substitute. I get an "unknown keyin" error. I am using MicroStation SS10 08.11.09.916.
Thank you
There is no way to replace one horizontal with another. There should be....but there isn't.
You can copy verticals between 2 different horizontals and you can use simplify element to remove offset rules and make the offset element a stand alone ruled civil element.
You can use corridor reattach to reattach a corridor from one alignment to another.
Marc
Hi Marc,
We can do this in ORD using the "GEOMETRY SUBSTITUTE" command, but unfortunately this doesn't exist in v8i.
Regards,
Mark
OpenRoads Designer 2023 | Microstation 2023.1 | ProjectWise 2023
Mark,
That key in does seem to work. It will replace a horizontal element and even carry over profile named boundaries. I am curious, have you tested this through reference file? I only tested it in one file. Anything you have found where it does not work?
Thanks for the tip.
The only time this usually doesnt work is if the existing and proposed replacement Geometry have relationships to each other. The easy solution is to use the "GEOMETRY SIMPLIFY" command on the old geometry and it should work fine.
Note that the tool can sometimes have issues if the start and end points of the old geometry matches the new, but we have had a lot of success with it (still wondering why it is not exposed to users with an icon as is a lifesaver a lot of the time).