Extract Vertical Profile from Linear Template

RE: Extract Vertical Profile from Linear Template

Michael Veerman — Fri, 13 Jan 2023 22:26:27 GMT

Hi Mark, just an update. I managed to make the vertical profile "readable" after isolating the linework:

RE: Extract Vertical Profile from Linear Template

Michael Veerman — Fri, 13 Jan 2023 22:26:23 GMT

Hi Mark, just an update. I managed to make the vertical profile "readable" after isolating the linework:

RE: Extract Vertical Profile from Linear Template

Michael Veerman — Wed, 11 Jan 2023 18:24:32 GMT

Thank you so much, Mark.

I am hoping there is a way to manipulate ORD to allow AQR to recognize the vertical profile from one of the pieces of the linear template.

RE: Extract Vertical Profile from Linear Template

Mark Shamoun — Wed, 11 Jan 2023 03:59:13 GMT

ahh makes sense - i have found Transoft support is quite good and have applied a few ORD compatibility fixes with Autoturn i have raised with them over the years. I would lodge a ticket with them about this as it may be a compatibility issue they have on their end.

RE: Extract Vertical Profile from Linear Template

Michael Veerman — Wed, 11 Jan 2023 02:39:52 GMT

Hi Mark, Thank you for your response.

This is actually for AQCESSRAMP which is by the same company as AutoTURN. AQCESSRAMP represents a major technological leap forward for streamlining curb ramps design that are compliant with regional guidelines.

AQCESSRAMP is performed in plan view and it works well as long as the geometry has a vertical profile associated with it.

RE: Extract Vertical Profile from Linear Template

Mark Shamoun — Wed, 11 Jan 2023 01:45:09 GMT

Hi Michael,

It looks like you are trying to use Vertical Simulation in Autoturn. You should use your Profile view for this - it does not use 3d design features.

AutoTURN 9.0 -- Place Vertical Simulations - YouTube